Water main installation cost

Installing, replacing, or repairing an existing water main can often times be quite costly. Having a brand new water main installed is the most costly of the three procedures. Prices change according to the location of the property and type of property, whether residential or commercial, and can vary from city to city and state to state. Many local plumbing companies provide price listings for water main installations on their websites and offer free estimates to make it easier for customers to shop around and find the lowest price for the best work. Depending on where the property is located, state taxes may cover a portion of the repair costs. The total amount of water usage also effects the projected cost of water main installation, but generally the cost can range between anywhere from $3,500 to over $1,000. It is a good idea to get an estimate of water main installation cost and set the money aside even if you haven't had a broken water main, just in case something does happen to your. To prevent having to spend so much money on the replacement of a water main, you should maintain your pipes by having them cleaned regularly and properly insulated. The need to install a water main may arise due to earth load or traffic, frost load, working pressure, and surge pressure; however, properly maintaining your water mains can add up to fifty years to the life of your water pipes, and doing so may mean that you avoid the water main installation entirely cost. Examination of break history can help a professional prevent a future break, but these forecasts should not be considered predictors of actual breaks. Predictions made this way can be useful for planning your own personal annual budgetary needs.

Install a water main

Be sure to follow closely proper installation guidelines. Water main installation cost should not be a concern. While there is no way to cut costs here, when the correct procedure is followed you will be saving money in the long run by eliminating the need for water main repair later. If you plan on having a brand new water main installed, you may have to go without water for a little while, or put up with diminished water pressure or volume. A new water main should be disinfected after construction is completed and the process should be up to the standards of the most recent version of American Water Works Association. Chemicals used to disinfect should be up to standards. After disinfections are completed and prior to placing a storage tank into active service, a water sample representative of stored water in the storage tank should be collected and analyzed for total bacteria, total and free chlorine residual, and physical parameters. Test results should meet the water quality standards before you place a new water main into active service. Samples should be collected after chlorine levels have been reduced to levels typically found in the system. If the original bacteria sample is positive, two repeat enumerated samples should be collected at least 24 hours apart. If two samples show the presence of bacteria, the storage tank should be disinfected again. Chlorine levels should be brought down to the levels normally found in the distribution system before the water is used for consumption.

Interested in water main installation? Get your project started by submitting a free BuyerZone request for septic system price quotes.